1. Peel back  label as shown  in picture.

2. Using the plug extraction tool provided screw into the recessed area under the label until screw fully penetrates cartridge.

3. Assemble the syringe and filling needle and fill with the appropriate colour ink.

4. Very slowly inject up to 10 ml of  ink  into  the sponge  until  the cartridge is full.

5. Seal   the   hole  made  in  the  top  label  with  adhesive   tape.

Note:  If  the holes are not sealed properly the cartridge will  leak.

6. Unused ink may be returned  to the  bottle.  Clean  the  syringe with water and  dry for future use, or use  with  a  different  colour ink.

7. Replace the  cartridge and   run  1 - 3  cleaning  cycles  as  per printer instructions.  If necessary leave cartridge in printer  for  up to 24 hours. (Allows ink to flow to the print head ).

Note:   If cartridge is refilled  before  it  is  completely  empty  this time  is greatly reduced.

Back to Refill Instructions Table