1. Peel back the sticky label to reveal the filling hole.(See diagram) 

2. Assemble  the   syringe   and   filling   needle  and   fill  with  ink. 

3. Insert the syringe  through  the  filling  hole,  and  push  into  the centre of the cartridge. (Enlarge filling hole if necessary with screw provided )

Note:  The cartridge contains sponge and a slight resistance may be felt. 

4. Slowly inject up to 5ml. of ink  or until ink  appears at  the  filling hole. 

5. Unused ink may be returned to the  bottle.   Clean  the  syringe with water and dry for future use, or use with a different colour ink. 
6. Replace the cartridge and run  a  priming  cycle  as  per  printer instructions. 

The  procedure  is  as   above except the  syringe  must  not be inserted more than  6  mm into the black cartridge, as the gauze  to  the  outlet  hole may be damaged.  Be careful to inject the correct colour ink. Clean the syringe  with  water and  dry   before   use  with  a  different    colour    ink.

---

Back to Refill Instructions Table