1. Make a filling hole in the base of the cartridge using a small drill, bradawl, or other pointed implement. Temporarily  seal  the  outlet hole   with   adhesive  tape  ( See diagram ). 

2. Assemble  the  syringe  and   filling   needle   and   fill   with  ink. 

3. Insert the  filling  needle  through  the  hole  and  push  into  the centre   of   the   cartridge.

Note:  The cartridge contains sponge and a slight resistance may be  felt.

4. Slowly inject up to 15ml. of ink, or until ink appears at the filling hole. 

5. Seal the filling hole with strong adhesive tape, and  unseal  the outlet  hole. 

6. Unused ink may be returned to  the  bottle.  Clean  the  syringe with  water   and   dry   for   future   use. 

7. Replace the cartridge and run a  priming  cycle  as  per  printer instructions. 

---

Back to Refill Instructions Table