1. The filler holes of the cartridge are located under the green top. The green top must be removed before refilling by 
carefully levering off with a thin metal blade, such as a thin flat blade screwdriver. Alternatively lay the cartridge on its 
side, hold down firmly, and strike the green top with a blunt instrument to break its seal. 

2. Assemble the syringe and filling needle and fill with the correct colour ink. 

3. Insert the filling needle into the filler hole of the colour to be refilled, (see diagram above) and push downwards until the filling needle  reaches the centre of the cartridge. 

Note: The cartridge contains sponge and a slight resistance may be felt. 

4. Slowly inject up to 10 ml. of ink until the ink surfaces around the injector.

Important: The original color of the sponge is white. In order to avoid overfilling the cartridge do not change the colour of the sponge to the colour you are filling. When the ink just begins to surface where the needle is inserted, stop filling, the cartridge is full.

5. Clean the syringe with water, and dry before refilling another colour. 

6. After refilling the top can be refitted and secured with adhesive tape.

Note: Empty cartridges should be refilled immediately.

Back to Refill Instructions Table