1. Assemble  the  syringe  and   filling   needle   and   fill   with   ink.

2. Hold the cartridge upright and push the needle through the filling hole into the centre of the cartridge. (Remove plug from filling hole on HP51633A ).

Note:  The cartridge contains sponge and a slight resistance  may be  felt.

3. Slowly inject up to 15 ml. of ink or until ink appears at  the  filling hole.

4. Stand  cartridge,  print  head  down,  on  absorbent  paper  for 2 minutes to draw out any excess ink and equalize  pressure within.

5. Unused ink may be returned  to  the  bottle.  Clean  the  syringe with water and dry  for  future  use.  ( Replace  plug  to  filling  hole on HP51633A)

Note: Empty cartridges should be refilled immediately.

Back to Refill Instructions Table